Well finally got them fitted, thanks to Martyn for wrapping them, I know it was a pain in the rear 
I am happy with them so they are fitted
I am happy with them so they are fitted
carbon fibre wing mirror
- Thread starter Procomm
- Start date
Now that's different! CF sprouting up all over the place
When are you getting the other one done Paul?
...........................................................................................................................
When are you getting the other one done Paul?
...........................................................................................................................
Well finally got them fitted, thanks to Martyn for wrapping them, I know it was a pain in the rear
I've been looking closely at this shot and i'd like to see a wider angle of the whole car. I think this is just enough Paul, the effect with the standard mirror cap is right, imo if you were to stick CF caps on there, then it might be too much CF.
didn't want to go down the root of carbon caps Al, I was intending all the black plastic on the outside of my car to be carbon fibre but not sure if the runners can be done (the ones that look pitted on nearly every cougar) with regard to the mirror I think this is a perfect case of less looks better
just taken some more pics, hopefully these will show the mirrors to their potential, like I said I am happy with them
Spot on Paul, and like i said in my thread over there .......... Cf can be a pig to photograph, light and shade an all that, but yes, these are going to look better in the flesh.
It's a shame about the rails, if the rear quarter glass seal could be done to match, then it would be a good look imo, but that seal is a stumbling block for matching anything other than oem. Then again, brainwave for a change, Like the chrome stuff that Tim and a few others have used, can you not buy that with the CF effect?
It's a shame about the rails, if the rear quarter glass seal could be done to match, then it would be a good look imo, but that seal is a stumbling block for matching anything other than oem. Then again, brainwave for a change
, Like the chrome stuff that Tim and a few others have used, can you not buy that with the CF effect?
only seen it with the vinyl wrap effect which doesn't look right in my opinion, then again I have a plan for the quarters that I started yesterday, might have a go at wrapping the rails in carbon myself as I have all the stuff required
Screwed on mate. Pull the seal downfrom the top and you'll see loads of cross head screws. Be aware of the white plastic popper in the top rear of the seal which holds the seal tight into the corner, and the one screw that lives behind the winglet.
got a couple of little bits that need sanding back and relaquering but I think Mart had struggled with them for long enough, gives me something to do aswell which is a bonus whilst i'm unemployed