Cougar S Upper Spoiler.

Muzntgrumble said:
Looks nice matey, well done, was going to put one of these on one of my past cars but didn't get around to it, got me thinking again now. (y)
Click to expand...


To be fair it was not that hard in the end, you do need some with you to help line it up. It took me about 30 mins all in with some messing around with the washer jet cut out, but all in job done.
 
Hey Pete - that's looking good matey. I've recently done mine too. I had a small issue with one side lifting after I had used Tigerseal on it, so had to re-seal it again and then stick a load more weight on top of it. Tell me, did you use the whole tube of Tigerseal? as I didn't , but now thinking I should have. This is mine after I finished it:

UpdatedCougPics-Sept2012019.jpg
 
WildV6 said:
Hey Pete - that's looking good matey. I've recently done mine too. I had a small issue with one side lifting after I had used Tigerseal on it, so had to re-seal it again and then stick a load more weight on top of it. Tell me, did you use the whole tube of Tigerseal? as I didn't , but now thinking I should have. This is mine after I finished it:

UpdatedCougPics-Sept2012019.jpg
Click to expand...

I used 1/2 a tube of it, but I did spread it out all over the underside if it + I use 3 20 litre tins of paint on it to weigh it down. These were very heavy and took 2 of us to lift them onto the roof of the car. I guess time will tell if it stays stuck down, if it does not then I will have to think of another way of doing it.
 
I'm sure it will stay down peter, I used 1 full tube to fit my whole kit and its not budged, its good stuff that tiger seal!
 
You must log in or register to reply here.