Post a pic of your cat here

I'm sure you're under-estimating yourself mate.

Not at all Al, the car is getting old and was a little rough round the edges anyway, small dents and paint faded etc, i have just managed to cover most of it, but there are minor details that are noticeable close up.. if we ever get a summer i will address what i can then.. (y)
The bonnet is the main bit as it needs a sanding back and a lacquer as it's quite dull in places, but it's ok for now..
 
Our cats!

20130401_185721_zps545dcbe2.jpg
 
I never noticed before that the standard Puma alloys are essentially fan blades directing air at the brakes. Neat.
 
Nice and clean for a change.....even did the inside! :what::eek: all ready for squires meet tomorrow uploadfromtaptalk1365274737723.jpg
 
Don't think i've posted a picture of the old girl up yet! Though i'd take a couple of pictures post wash while the sun was actually kind of out!


photo hosting


free image hosting

My favourite view of any Cougar ^


It's soon to reach 180,000 but still quite straight I think :)

Sam.

I could swear I've seen that around Rugby? Unless there's another greenie out there with an extremely similar reg?
 
Better shot of the wheels for mark :cool:
uploadfromtaptalk1365275903914.jpguploadfromtaptalk1365275927228.jpg

Once the weather gets a little warmer im going to refurb the lips and repaint the spokes and give them a generous coat of laquer, should look good as new :)
 
I took my coug for a spin down to Tintagel a couple of days ago whilst it was good weather. She had a completely flat battery after being stood for almost 5 months. Anyway, a quick jump start and away she went. Battery is now fully charged once more (I really need to run her more often!! Oops!! ) Anyway here is a quick pic over looking Tintagel:

FordStickersandTintagel050413013_zpsb931a5cf.jpg
 
John's Frosty.jpg
Gave my frosty a bit of shizzle and dizzle
Wheels, gutters and channels needed a good sorting out with a bit of kitchen cloth
Been sorting out the famous throttle hang issue but will be reporting on that elsewhere
Started out to chop the single exhaust trim to Steve's dual outlet and discovered all my cutting tools were at work - next weekend?!?!?!